Custom Built Pro-street Chopper, 300 Rigid on 2040-motos

Pro Street Pro Street description

Up for your consideration is my custom built pro-street rigid. The bike is listed as an 08 but has less than 300 miles on it. The custom features are extensive so I'm sure I will forget something. I started with a Pro Street Frame Works 300 tire drop seat rigid frame with 7" of backbone stretch and 52 degrees of rake. The frame was completely smoothed and molded. The oil bag location under the seat is actually the battery box and also houses the coils and other electronics. The oil bag is under the transmission.

The front end on this build is from American Suspension. I believe they called it the Dragon Fly. It is only 1" over but looks much longer due to the rake. Ride Wright Wheels built the 80 spoke spool front wheel and its running a Metzeler ME880 90-90X21. Rear wheel is Ride Wright 80 Spoke 18x10.5 wrapped with a ME880 300x18 stopped by a  Hawg Halter Sprotor.

Cutting Edge Choppers helped us on the handlebars and foot controls. The bars were built on the bike for the perfect angle and width. Both throttle and clutch are twist for a really clean looking setup. The foot control linkages are under the primary and motor, a feature unique to Cutting Edge.

H&L built us one of their 113 billet motors that makes around 135HP. Feeding this beast is an Zippers S&S chrome Super G with thunder jet. Zippers built this carb to the motors specs for the perfect tune. Exhaust was built by the infamous Frankie Serrano from Florida. If you are not familiar with Frankie, he designed and built all the exhaust for Eddie Trotta at Thunder Cycle Design before going out on his own. This is one sick motor.

The primary is a Kenny Boyce 4" belt drive running a Scorpion clutch. Tranny is a Prowler right side drive 6 speed.

After the frame, tank and fender were all smoothed out they were covered with a special blend of flake which was topped with a custom mix House of Color green candy by the award winning painter Alvie. Gold leaf and pin striping were done by DeGrosso then Alvie buried everything in clear and hand rubbed it to a mirror like finish.

All wiring, clutch and brake lines are run internal for a super clean look. The detail on this bike is simply amazing. It has multiple Best In Show wins and gets tons of attention where ever it goes.

Needless to say there is a ton of money invested in this bike as well as countless hours. It can be yours for a fraction of the cost of the build.

Shipping will of course be the responsibility of the buyer but I will assist in anyway I can. I use Keyboard Motorcycle Carriers personally. Reasonable and very used to hauling high end bikes.

If you have any questions please call Jerry at Yolo County Choppers, 530-666-1237 or 530-219-9391.

Thanks for looking.